Engine Block

Component Location Index

See also:

Ignition Timing Inspection
1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (II). 3. Make sure the HDS communicates with the vehic ...

Interface Dial Removal/Installation
1. Remove the audio unit (see page 23-114). 2. Remove the screw and harness cover (A). 3. Disconnect the interface dial connector (A). Remove the screws and interface dial (B). NOTE: If the ...

Drive Belt Removal/Installation
Special Tools Required Belt Tension Release Tool Snap-on YA9317 or equivalent, commercially available 1. Move the auto-tensioner (A) with the belt tension release tool (B) in the direction of the ...