Engine Electrical

Starting System

See also:

Power Window Master Switch Input Test
NOTE: Before testing, troubleshoot the multiplex Integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). 1. Turn the ignition switch to LOCK (0), open and clos ...

Alternator Control Circuit Troubleshooting
NOTE: Do this troubleshooting if, in step 5 of the alternator and regulator circuit troubleshooting (see page 4-27), the battery voltage is less than 13.5 V. * 1. Connect the Honda Diagnostic Sys ...

Control Unit Input Test/Replacement
1. Remove the driver's dashboard lower cover (see page 20-166). 2. Remove the screws, then disconnect the 28P connector (A) from the HandsFreeLink control unit (B). 3. Inspect the connector an ...