Honda Accord: Spark Plug Inspection - Ignition System - Engine Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Spark Plug Inspection

1. Remove the ignition coils (see page 4-20).

2. Remove the spark plugs, then inspect the electrodes and the ceramic insulator.

- Burned or worn electrodes may be caused by these conditions:

- Advanced ignition timing

- Loose spark plug

- Plug heat range too hot

- Insufficient cooling

- Fouled plugs may be caused by these conditions:

- Retarded ignition timing

- Oil in combustion chamber

- Incorrect spark plug gap

- Plug heat range too cold

- Excessive idling/low speed running

- Clogged air cleaner element

- Deteriorated ignition coils

3. If the spark plug electrode is dirty or contaminated,


3. If the spark plug electrode is dirty or contaminated, clean the electrode with a plug cleaner.

NOTE:

- Do not use a wire brush or scrape the iridium electrode since this will damage the electrode.

- When using a sand blaster spark plug cleaner, do not clean for more than 20 seconds to avoid damaging the electrode.

4. Replace the plug at the specified interval, or if the center electrode is rounded (A), or if the spark plug gap (B) is out of specification. Use only the spark plugs listed.

NOTE: Do not adjust the gap of iridium tip plugs.

All models except PZEV

Spark Plugs

NGK: IIZKR7B-11S

DENSO: SXU22HCR11S

Electrode Gap

Standard (New): 1.0-1.1 mm (0.039- 0.043 in)

PZEV model

Spark Plugs

NGK: DILZKR7A11GS

Electrode Gap Standard (New): 1.0-1.1 mm (0.039-0.043 in)

All models except PZEV

PZEV model


PZEV model

5. Apply a small amount of anti-seize compound to the


5. Apply a small amount of anti-seize compound to the plug threads, and screw the plugs into the cylinder head, finger-tight. Torque them to 18 Nm (1.8 kgf-m, 13 Ibfft).

    Ignition Coil and Spark Plug Removal/Installation
    1. Remove the ignition coil cover (A). 2. Disconnect the ignition coil connectors (B), then remove the ignition coils (C). 3. Remove the spark plug and inspect them (see page 4-20). 4. Appl ...

    Charging System
    ...

    See also:

    Braking System
    Your vehicle is equipped with disc brakes at all four wheels. A power assist helps reduce the effort needed on the brake pedal. The emergency brake assist system increases the stopping force ...

    Circuit Diagram
    '08-09 Models With Navigation '10 Model With Navigation   '08-09 Models Without Navigation '10 Model Without Navigation ...

    B-CAN System Diagnosis Test Mode 1 and Test Mode 2 (without the HDS)
    Special Tools Required MFCS (MCIC) Service Connector 07WAZ-00101 OA Test Mode 1 Check the ECM/PCM for DTCs and troubleshoot ECM/PCM (see p a g e 11-3) or F-CAN loss o f communication errors first ...