Honda Accord: Shift Lock Release, Release Spring, and
Release Shaft Replacement - A/T interlock System - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Shift Lock Release, Release Spring, and Release Shaft Replacement

Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Transaxle / A/T interlock System / Shift Lock Release, Release Spring, and Release Shaft Replacement

Type A Shift Lever

1. Remove the shift lever assembly (see page 14-222).

2. Remove the A/T gear position indicator panel from the shift lever (see page 14-227).

3. Release the lock (A) of the shift lock release, and remove the shift lock release and the release spring (B).

4. Release the lock (C) of the release shaft, and remove


4. Release the lock (C) of the release shaft, and remove the shaft (D).

5. Replace the shift lock release, the release spring, or the release shaft.

6. Install the release spring (A) in the shift lock release (B).

7. Install the release shaft (C) in the shift lever, and install


7. Install the release shaft (C) in the shift lever, and install the shift lock release and the release spring on the release shaft end.

8. Make sure that the release spring end (A) is installed in the shift lock release (B), and the hooked end (C) is on the stop (D).

9. Install the A/T gear position indicator panel on the


9. Install the A/T gear position indicator panel on the shift lever (see page 14-227).

10. Install the shift lever assembly (see page 14-224).

    Shift Lock Stop/Shift Lock Stop Cushion Replacement
    Type A Shift Lever 1. Remove the shift lock solenoid (see page 14-254). 2. Remove the shift lock stop (A) and the stop cushion (B) as a set. 3. Apply silicone grease to the pin (C) of the shif ...

    Park Pin Switch Replacement
    Type A Shift Lever NOTE: The AfT gear position indicator panel light harness and the park pin switch are not available separately. Replace the A/T gear position indicator panel light harness and t ...

    See also:

    VSA Off Switch Test
    1. Turn the ignition switch to LOCK (0). 2. Remove the driver's dashboard lower cover {see page 20-166). 3. Push out the VSA OFF switch (A) from the driver's dashboard lower cover. 4. Check ...

    Power Window Master Switch Input Test
    NOTE: Before testing, troubleshoot the multiplex Integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). 1. Turn the ignition switch to LOCK (0), open and clos ...

    Brake Booster Replacement
    1. Remove the cowl cover (see page 20-278). 2. Remove the strut brace (if equipped) (see page 20-306). 3. Remove the master cylinder (see page 19-26). 4. Disconnect the brake booster vacuum ...