Honda Accord: Shift Fork Clearance Inspection - Manual Transmission - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Shift Fork Clearance Inspection

1. Measure the clearance between each shift fork (A) and its matching synchro sleeve (B). If the clearance exceeds the service limit, go to step 2.

Standard: 0.35-0.65 mm (0.014-0.026 inj

Service Limit: 1.0 mm (0.04 in)

2. Measure the thickness of the shift fork fingers.


2. Measure the thickness of the shift fork fingers.

- If the thickness is not within the standard, replace . the shift fork.

- If the thickness is within the standard, replace the synchro sleeve and the synchro hub as a set.

- If one arm of the shift fork shows more wear than others, the fork may be bent and needs to be replaced.

Standard: 7.4-7.6 mm (0.29-0.30 in)

3. Measure the clearance between the shift fork (A) and


3. Measure the clearance between the shift fork (A) and the shift arm (B). If the clearance exceeds the service limit, go to step 4.

Standard: 0.2-0.5 mm (0.01 - 0 . 0 2 in)

Service Limit: 0.6 mm (0.02 in)

4. Measure the width of the shift arm.


4. Measure the width of the shift arm.

- If the width is not within the standard, replace the shift arm.

- If the width is within the standard, replace the shift fork.

Standard: 16.9-17.0 mm (0.665-0.669 in)

 


    Change Lever Assembly Disassembly/Reassembly
    NOTE: Prior to reassembling, clean all the parts in solvent, dry them, and apply grease to contact surfaces as shown. Do not wash the rubber parts with solvent. ...

      Shift Fork Disassembly/Reassembly
    NOTE: Prior to reassembling, clean all the parts in solvent, dry them, and apply MTF to all contact surfaces ...

    See also:

    How the Passenger Airbag Off Indicator Works
    This indicator alerts you that the passenger’s front airbag has been shut off because weight sensors detect about 65 lbs (29 kg) or less (the weight of an infant or small child) on the f ...

    A/C Compressor Clutch Check
    1. Check the pressure plate for discoloration, peeling, or other damage. If there is damage, replace the clutch set (see page 21-75). 2. Check the pulley bearing play and drag by rotating the pu ...

    Rear Door Panel Removal/Installation
    Special Tools Required -KTC Trim Tool Set SOJATP2014 - Trim Pad Remover Snap-on A 177A, commercially available *Available through the Honda Tool and Equipment Program; call 888-424-6857 4-door ...