Honda Accord: Selector Control Shaft Oil Seal
Replacement - Transmission End Cover - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Selector Control Shaft Oil Seal Replacement

Special Tools Required

-Driver Handle, 15 x 135L 07749-0010000

•Attachment 22 x 24 mm 07746-001A800 1. Remove the oil seal (A) from the end cover (B).

2. Install a new oil seal flush to the end cover using the


2. Install a new oil seal flush to the end cover using the driver handle and the 22 x 24 mm attachment.

Selector Centre! Sheft Bearing


    Idler Gear Shaft Bearing Replacement
    Special Tools Required -Adjustable Bearing Puller, 25—40 mm 07736-A01000B •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 52 x 55 mm 07746-0010400 1. Remove the idler gear shaft be ...

    Selector Centre! Sheft Bearing Replacement
    Special Tools Required •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 22 x 24 mm 07746-001A800 1. Remove the oil seal from the end cover, then remove the bearing. 2. Install a new be ...

    See also:

    Stall Speed Test
    1. Wake sure the transmission fluid is filled to the proper level (see page 14-191). 2. Apply the parking brake, and block all four wheels. 3. Connect the HDS to the DLC (A) located under the ...

    TPMS (Tire Pressure Monitoring System)
    Instead of directly measuring the pressure in each tire, the TPMS on this vehicle monitors and compares the rolling radius and rotational characteristics of each wheel and tire while you are dri ...

    Rear Seat-back Release Lever/Cable Removal/Installation
    NOTE: - Take care not to bend or scratch the interior trim. - 4-door is shown; 2-door is similar. 1. Remove the rear shelf (see page 20-128). 2. Disconnect the seat-back release cable (A) fr ...