Honda Accord: Selector Centre! Sheft Bearing
Replacement
Special Tools Required
•Driver Handle, 15 x 135L 07749-0010000
-Attachment, 22 x 24 mm 07746-001A800
1. Remove the oil seal from the end cover, then remove the bearing.
2. Install a new bearing flush to the end cover using the driver handle and the 22 x 24 mm attachment.
3. Install a new oil seal.
Selector Control Shaft Oil Seal
Replacement
Special Tools Required
-Driver Handle, 15 x 135L 07749-0010000
•Attachment 22 x 24 mm 07746-001A800
1. Remove the oil seal (A) from the end cover (B).
2. Install a new oil seal flush to the ...
ATF Feed Pipe Replacement
1. Remove the snap rings (A), the ATF feed pipes (B),
and the feed pipe flanges (C) from the end cover (D).
NOTE: Replace the end cover, if the 1st clutch ATF
feed pipe (E) replacement is require ...
See also:
Rear Seats
• Folding Down the Rear Seat
1. Remove the center shoulder belt from the
guide.
2. Pull the release lever in the trunk to release
the lock.
3. Fold the seat-back down.
If the rear head ...
Maintenance MinderTM
If the engine oil life is less than 15%, you will see the Maintenance Minder
messages
appear on the information display* or the multi-information display* every time
you
turn the ignition swit ...
Accessory Power Socket Trim
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the console.
- Use the approp ...