Honda Accord: Security Hood Switch Test
1. Open the hood.
2. Disconnect the 2P connector from the security hood switch.
3. Check for continuity between the terminals.
• There should be continuity between terminals No. 1 and No. 2 when the hood is opened (latch released).
• There should be no continuity between terminals No. 1 and No. 2 when the hood is closed (latch pushed down).
4. If the continuity is not as specified, replace the hood latch assembly (see page 20-302).
Door Key Cylinder Switch Test
1. Remove the driver's door panel (see page 20-17).
2. Disconnect the 10P connector (A) from the door lock
actuator (key cylinder switch) (B).
3. Check for continuity between the terminals.
...
Trunk Lid Release Actuator Test
With Keyless Entry
1. Open the trunk lid.
2. Disconnect 3P connector f r om the trunk lid latch
switch/trunk release actuator.
3. Check actuator operation by connecting power to
terminal No. ...
See also:
Side Turn Signal/Emergency Indicator Light Bulbs*
Door mirrors have the side turn lights. Have an authorized Honda dealer
inspect and
replace the light bulbs.
...
Voice Control Operation
Your vehicle has a voice control system that allows hands-free operation of
most of
the navigation system functions.
The voice control system uses the
(Talk) and (hang-up/back) buttons
on ...
Rear Brake Disc Replacement
NOTE: Keep any grease off the brake disc and the brake
pads.
1. Raise and support the vehicle (see page 1-13).
2. Remove the rear wheel.
3. Release the parking brake lever fully.
4. Loose ...