Honda Accord: Secondary Shaft Idler Gear Removal
and Installation - Shafts and Clutches - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Secondary Shaft Idler Gear Removal and Installation

Special Tools Required

Attachment 42 mm I.D. 07QAD-P0A0100

Removal

Place a spacer (A) on the secondary shaft (B), and set a puller (C) under the idler gear (D), then remove the idler gear.

Installation


Installation

Install the idler gear (A) in the direction shown on the secondary shaft (B) using the 42 mm attachment and a press.

Secondary Shaft 2nd Gear Axial


    Secondary Shaft Disassembly, Inspection, and Reassembly
    1. Inspect the thrust needle bearings a n d the needle bearings for g a l l i n g and rough movement 2. Inspect the splines for excessive wear and damage. 3. Check the shaft bearing surface fo ...

    Secondary Shaft 2nd Gear Axial Clearance Inspection
    1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), t ...

    See also:

    Power Mirror Actuator Replacement
    Removal 1. Remove the mirror holder (see page 20-63). 2. Remove the power mirror (see page 20-62), and disconnect the power mirror 8P connector from the door wire harness. 3. Remove the gaske ...

    Checking Wiper Blades
    If the wiper blade rubber has deteriorated, it will leave streaks and the metal wiper arm may scratch the window glass. ...

    Clutch Hose Replacement
    NOTE: - Replace the clutch hose if it is twisted, cracked, or leaks. - Use fender covers to avoid damaging painted surfaces. - Do not spill brake fluid on the vehicle; it may damage the pain ...