Honda Accord: Secondary Shaft 2nd Gear Axial
Clearance Inspection - Shafts and Clutches - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Secondary Shaft 2nd Gear Axial Clearance Inspection

1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), then secure them with the set ring ( H ) . Do not install the O-rings during inspection.

2. Measure the clearance between the set ring (A) and


2. Measure the clearance between the set ring (A) and the 2nd clutch guide (B) using a feeler gauge (C), in at least three places. Use the average as the actual clearance.

Standard: 0.04-0.12 mm (0.002-0.005 in)


3. If the clearance is out of standard, remove the


3. If the clearance is out of standard, remove the 37 x 58 mm thrust washer, and measure its thickness.

4. Select and install a new thrust washer, then recheck.

THRUST WASHER, 37 x 58 mm

5. After replacing the thrust washer, make sure the


5. After replacing the thrust washer, make sure the clearance is within standard.

6. Disassemble the installed parts from the secondary shaft.

    Secondary Shaft Idler Gear Removal and Installation
    Special Tools Required Attachment 42 mm I.D. 07QAD-P0A0100 Removal Place a spacer (A) on the secondary shaft (B), and set a puller (C) under the idler gear (D), then remove the idler gear. Ins ...

    Secondary Shaft 1 st Gear Axial Clearance Inspection
    Special Tools Required Attachment, 42 mm I.D. 07QAD-P0A0100 1. Remove the secondary shaft transmission housing bearing (see page 14-270). 2. Install the thrust needle b e a r i n g (A), the need ...

    See also:

    Driver's Dashboard Lower Cover Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* * Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE; - Take care not to scratch the dashboard or the related p ...

    HFL Menus
    The ignition switch must be in ACCESSORY or ON to use HFL. • Phone Settings screen To use HFL, you must first pair your Bluetoothcompatible cell phone to the system while the vehicle is ...

    Tire Labeling
    The tires that came on your vehicle have a number of markings. Those you should be aware of are described below. • Tire Sizes Whenever tires are replaced, they should be replaced with tires ...