Honda Accord: Seats
- Component Location Index
- Front Seat Active Head Restraint Inspection
- Front Seat Removal/Installation
- Front Seat Recline Motor Replacement
- Front Seat Lumbar Support Replacement
- Front Seat Slide Motor Replacement
- Front Seat Slide Lever Replacement
- Front Seat Torsion Bar Replacement
- Rear Seat Access Cable Replacement
- Front Seat Frame Replacement Driver's Seat
- Front Seat Frame Replacement - Passenger's Seat
- Front Seat-back Cover Replacement
- Front Seat Cushion Cover Replacement
- Rear Seat Removal/Installation
- Rear Seat-back Latch Replacement
- Rear Seat-back Release Lever/Cable Removal/Installation
- Rear Seat Armrest Replacement
- Trunk Pass-through Lid Lock Cylinder Replacement
- Trunk Pass-through Lid Replacement
- Rear Seat Armrest Beverage Holder Replacement
- Rear Seat-back Cover Replacement
- Rear Seat Side Bolster Cover Replacement
- Rear Seat Cushion Cover Replacement
Dashboard/Steering Hanger Beam
Disassembly/Reassembly
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Put on gloves to protect your hands.
В© Take care no ...
Component Location Index
2-door
4-door
...
See also:
Front Passenger's Weight Sensor Replacement
4-Door
Removal
NOTE;
• Removal of the front passenger's weight
sensors must
be done a c c o r d i n g to Precautions and Procedures (see
page 24-25).
•The front passenger' s weight ...
Parking Light Bulbs
When replacing, use the following bulbs.
Turn the steering wheel and pull the inner fender back in the same way as
when
replacing the front turn signal/side marker light bulbs.
1. Turn the s ...
EVAP Canister Vent Shut Valve
Replacement
1 o Disconnect the EVAP canister vent shut valve 2P
connector (A).
2. Remove the cap (B).
3. Remove the EVAP canister vent shut valve (C).
4. Install the parts in the reverse order of remova ...