Honda Accord: Seat Heaters
EX-L and all V6 models
Both front seats are equipped with seat heaters. Because of the sensors for the side airbag cutoff system, there is no heater in the passenger’s seat-back. The ignition switch must be in the ON (II) position to use the heaters.
Push the right side of the switch, HI, to rapidly heat up the seat. After the seat reaches a comfortable temperature, select LO by pushing the left side of the switch. This will keep the seat warm.
In the HI setting, the heater turns off when the seat gets warm, and turns back on after the seat’s temperature drops.
In the LO setting, the heater runs continuously. It does not cycle with temperature changes.
Follow these precautions whenever you use the seat heaters:
Use the HI setting only to heat the seats quickly, because it draws large amounts of current from the battery.
If the engine is left idling for an extended period, do not use the seat heaters even on the LO setting. It can weaken the battery, causing hard starting.
Folding Rear Seat
The back of the rear seat folds down, giving you direct access to the trunk. The seat-back is released from inside the trunk. When storing cargo, you can move the rear center shoulder belt o ...Driving Position Memory System
U.S. V6 models, and Canadian EX-L and V6 models with navigation system Your vehicle has a memory feature for the driver’s seat position. Seat, except for power lumbar, position can be stored ...See also:
Rear Seat Removal/Installation
Seat-back
NOTE; Take care not to scratch the body or tear the seat
covers.
3.Remove the seat-back (A).
-1. Pull out the center seat belt (B) through the slit (C) in
the seat belt guide (D).
...
How the SRS Indicator Works
The SRS indicator alerts you to a
potential problem with your airbag
system components.
When you turn the ignition switch to
the ON (II) position, this indicator
comes on briefly then goes ...
Training HomeLink
Before you begin - If you just
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first butto ...