Honda Accord: Seat Belt System Components
Your seat belt system includes lap/ shoulder belts in all seating positions.
The front seat belts are also equipped with automatic seat belt tensioners.
The seat belt system includes an indicator on the instrument panel and a beeper to remind you and your passengers to fasten your seat belts.
This system monitors the front seat belts. If you turn the ignition switch to the ON (II) position before your seat belt is fastened, the beeper will sound and the indicator will flash. If your seat belt is not fastened before the beeper stops, the indicator will stop flashing but remain on.
If a front passenger does not fasten their seat belt, the indicator will come on about 6 seconds after the ignition switch is turned to the ON (II) position.
If either the driver or a front passenger does not fasten their seat belt while driving, the beeper will sound and the indicator will flash again at regular intervals.
When no one is sitting in the front passenger’s seat, or a child or small adult is riding there, the indicator should not come on and the beeper should not sound.
If the indicator comes on or the beeper sounds when the driver’s seat belt is latched and there is no front seat passenger and no items on the front seat, something may be interfering with the monitoring system. Look for and remove:
- Any items under the front passenger’s seat.
- Any object(s) hanging on the seat or in the seat-back pocket.
- Any object(s) touching the rear of the seat-back.
If no obstructions are found, have your vehicle checked by a dealer.
Lap/Shoulder Belt
The lap/shoulder belt goes over
your shoulder, across your chest,
and across your hips.
To fasten the belt, insert the latch
plate into the buckle, then tug on the
belt to make sure the buckl ...
See also:
Temperature Gauge
This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise
from the bottom mark to about the
middle of the gauge. In severe
driving conditions, su ...
How to Use HFL
The ignition switch must be in the ACCESSORY (I) or ON (II) position.
To use HFL, you need to pair your
Bluetooth-compatible cell phone to
the system. ...
Transmission Number
Transmission Type
88E5: 5-speed Manual
M91 A: 5-speed Automatic
B90A: 5-speed Automatic
Serial Number
1000001-: M91A, B90A
8000001-: 88E5 ...