Roof and Trunk

Connectors and Harnesses

See also:

Connecting Rod Bearing Replacement
Connecting Rod Bearing Clearance Inspection 1. Remove the oil pump (see page 8-17). 2. Remove the baffle plate (see step 8 on page 7-14). 3. Remove the connecting rod cap and the bearing half. ...

Security Hood Switch Test
1. Open the hood. 2. Disconnect the 2P connector from the security hood switch. 3. Check for continuity between the terminals. • There should be continuity between terminals No. 1 and ...

Cylinder Head
Component Location Index (cont'd) Engine Compression Inspection NOTE: After this inspection, you must reset the engine control module (ECM)/powertrain control module (PCM), otherwise the ECM ...