Cylinder Head Installation

1. Install a new coolant separator (A) In the engine block whenever the engine block is replaced. 2. Clean the cylinder head and the engine block surface. 3. Install the new cylinder head gaske ...

Engine Block

...

See also:

Park Pin Switch Test
Produced in USA models 1. Remove the center console (see page 20-158). 2. Disconnect the A/T gear position indicator panel light/park pin switch 6P connector (A) from the park pin switch (B). ...

Preparing to Drive
You should do the following checks and adjustments before you drive your vehicle. 1. Make sure all windows, mirrors, and outside lights are clean and unobstructed. Remove frost, snow, or ic ...

Crossover Network Control Unit Removal/Installation
Driver's Door Speaker Crossover Network Control Unit 1. Remove the driver's dashboard lower cover (see page 20-166). 2. Disconnect the connector (A), then remove the driver's door speaker cross ...