Outside Air Temperature Sensor Replacement

1 Disconnect the 2P connector (A) from the outside air temperature sensor (B). 2. Lift the tab (C) to release the lock, then remove the outside air temperature sensor from the front bumper. 3 ...

Component Location Index

4-door 2-door ...

See also:

Clutch Wave-plate Phase Difference Inspection
1. Place the clutch wave-plate (A) on a surface plate, and set a dial indicator (B) on the wave-plate. 2. Find the bottom (C) of a phase difference of the wave-plate, zero the dial indicator an ...

Receiver/Dryer Desiccant Replacement
NOTE: Install the receiver/dryer as quickly as possible to prevent the system from absorbing moisture from the air. 1. Remove the A/C condenser (see page 21 -77). 2. Remove the bolts from the ...

Wear Indicators
The groove where the wear indicator is located is 1/16 inch (1.6 mm) shallower than elsewhere on the tire. If the tread has worn so that the indicator is exposed, replace the tire. Worn out ...