Honda Accord: Reverse Shift Fork Clearance Inspection
1. Measure the clearance between the reverse Idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2.
Standard; 0.20-0.59 mm (0.008-0.023 In)
Service Limit: 1.2 mm (0.05 in)
Measure the width of the reverse shift fork.
- If the width is not within the standard, replace the reverse shift fork.
- If the width is within the standard, replace the reverse idler gear.
Standard: 13.4-13.7 mm (0.53-0.54 in)
Transmission Disassembly
Exploded View-Clutch Housing
1.DIFFERENTIAL ASSEMBLY
2.SHIFT FORK ASSEMBLY
3.6 mm FLANGE BOLT
13 N-m (1.3 kgf-m, 9.4 Ibf-ft)
4.BEARING SET PLATE
5.COUNTERSHAFT ASSEMBLY
6.NEEDLE BEARING
7.OI ...
Change Lever Clearance Inspection
1. Measure the clearance between the change lever (A)
and the select lever (B) with a feeler gauge (C). If the
clearance exceeds the service limit, go to step 2.
Standard: 0.05-”0.25 mm (0.002 ...
See also:
Moonroof Switch Test/Replacement
1. Remove the front Individual map lights (see page
22-258).
2. Disconnect the moonroof switch 12P connector (A)
and map light 3P connector (B).
3. Remove the moonroof switch (C) from the map ...
When Driving
...
Steering Wheel Installation
SRS components are located in this area. Review the
SRS component locations: 4-door {see page 24-21),
2-door (see page 24-23) and the precautions and
procedures (see page 24-25) before doing repair ...