Honda Accord: Reverse Idler Gear Removal and Installation
Removal
1. Remove the bolt (A) securing the reverse idler gear shaft holder (B).
2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear shaft (D), and pull it to remove the reverse idler gear shaft and the reverse idler gear shaft holder together.
3. Remove the reverse idler gear (A).
Installation
1. Install the reverse idler gear in the transmission housing.
2. Lightly coat the reverse idler gear shaft (A), the needle bearing (B), and new O-rings (C) with lithium grease.
3. Assemble O-rings and the needle bearing on the reverse idler gear shaft, then install the reverse idler gear shaft in the reverse idler gear shaft holder (D).
Align the D-shaped cut out (E) of the reverse idler gear shaft with the D-shaped area (F) of the reverse idler gear shaft holder.
4. Install the reverse idler gear shaft/holder assembly on the transmission housing.
Bearing Installation
Special Tools Required -Attachment, 78 x 80 mm 07NAD-PX40100 -Driver Handle, 15 x 135L 07749-0010000 -Bearing Driver Attachment, 42 x 47 07746-0010300 1. Install the bearings in the direction show ...Valve Body
...See also:
Crankshaft Inspection
Out-of-Round and Taper
1. Remove the crankshaft from the engine block (see
page 7-14).
2. Remove the crankshaft position (CKP) pulse plate
from the crankshaft (see page 7-30).
3. Clean the cr ...
Power Mirror Actuator Replacement
Removal
1. Remove the mirror holder (see page 20-63).
2. Remove the power mirror (see page 20-62), and
disconnect the power mirror 8P connector from the
door wire harness.
3. Remove the gaske ...
Circuit Diagram
...