Honda Accord: Resuming the Set Speed - Cruise Control - Features - Honda Accord 2008-2012 Owner's ManualHonda Accord: Resuming the Set Speed

When you push the CANCEL button, or tap the brake or clutch pedal, the system will remember the previously set cruising speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and release the RES/ACCEL button. The CRUISE CONTROL indicator comes on. The vehicle will accelerate to the same cruising speed as before.

Pressing the CRUISE button turns the system completely off and erases the previous cruising speed.

    Canceling Cruise Control
    You can cancel cruise control in any of these ways: Tap the brake or clutch pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel. ...

    HomeLink Universal Transceiver
    All V6 models The HomeLink universal transceiver built into your vehicle can be programmed to operate up to three remotely controlled devices around your home, such as garage doors, lightin ...

    See also:

    Rocker Arm Oil Pressure Switch Removal/Installation
    All models except PZEV 1. Disconnect the rocker arm oil pressure switch connector (A). 2. Remove the rocker arm oil pressure switch (B). 3. Install the parts in the reverse order of removal wi ...

    Lower Arm B Replacement
    1 Raise and support the vehicle (see page 1-13). 2. Remove the rear wheel. 3. Remove the lower arm B mounting bolts, then remove lower arm B. NOTE: Use new mounting bolts during reassembly. ...

    Storing a Driving Position in Memory
    Store a driving position only when the vehicle is parked. 1. Turn the ignition switch to the ON (II) position. You cannot add a new driving position to the memory unless the ignition switch ...