Control Unit Input Test/Replacement

1. Remove the driver's dashboard lower cover (see page 20-166). 2. Remove the screws, then disconnect the 28P connector (A) from the HandsFreeLink control unit (B). 3. Inspect the connector an ...

Seat Belts

...

See also:

Adding Engine Oil
1. Unscrew and remove the engine oil fill cap. 2. Add oil slowly. 3. Reinstall the engine oil fill cap, and tighten it securely. 4. Wait for three minutes and recheck the engine oil dipsti ...

Tie-rod End Ball Joint Boot Replacement
Special Tools Required Bearing Driver Attachment, 36 07965-SA50500 1 Disconnect the tie-rod end ball joint from the knuckle (see step 26 on page 17-41). 2. Remove the tie-rod end from the rack e ...

A/C Compressor Clutch Check
1. Check the pressure plate for discoloration, peeling, or other damage. If there is damage, replace the clutch set (see page 21-75). 2. Check the pulley bearing play and drag by rotating the pu ...