Honda Accord: Relay and Control Unit Locations
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Relay and Control Unit Locations
Body Electrical
Special Tools
General Troubleshooting Information
Tips and Precautions
Special Tools Required
Back Probe Adapter, 17 mm 07TAZ-001020A
1. Check applicable fuses in the appropriate fuse/relay
...
See also:
Status Log
If you suspect there is a immobilizer system problem, check the status log.
1. Connect the HDS to the data link connector.
2. Turn the ignition switch to ON (II).
3. On the HDS screen, at MAI ...
Immobilizer System
The immobilizer system protects
your vehicle from theft. If an
improperly coded key (or other
device) is used, the engine’s fuel
system is disabled.
When you turn the ignition switch to
t ...
Glass Weatherstrip Replacement
1 . Remove the moonroof glass (see page 20-91).
2. Place a piece of masking tape (A) on the middle of the
front edge of the moonroof glass (B). Make sure that
the tape is on the glass only, and i ...
