Honda Accord: Region Setting
The audio system’s region setting will be lost when the battery is disconnected or goes dead.
If the Region Select screen appears, you need to set the region for the audio system. Follow the steps below:
1. Press 
to select OK.
2. Rotate 
to select the region you
live in, then press 
.
3. You will receive a confirmation message on the screen. Rotate
to select Yes,
then press 
.
The region setting is required only when the battery power is temporarily disconnected. It is set to your vehicle’s region type by the factory.
You cannot change the setting once you have completed the setting procedure. Contact a dealer if you selected an incorrect region.
Audio System Theft Protection*
The audio system is disabled when it is disconnected from the power source,
such as
when the battery is disconnected or goes dead.
• Reactivating the audio system
1. Set the power mode to ON, ...
Audio Remote Controls
Allows you to operate the audio system while driving.
The CD mode appears only when a CD is loaded.
...
See also:
Circuit Diagram
...
MAP Sensor Replacement
1. Disconnect the MAP sensor connector (A).
2. Remove the MAP sensor (B).
3. Install the parts in the reverse order of removal with a
new O-ring (C). ...
Headlight Adjustment
Headlights become very hot during use; do not touch
them or any attaching hardware immediately after
they have been turned off.
Before adjusting the headlights:
• Park the vehicle on a level ...