Honda Accord: Recirculation Control Motor Test - Climate Control - Heating, Ventilation, and Air Conditioning - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Recirculation Control Motor Test

NOTE: Before testing the motor, check for HVAC DTCs (see page 21-101).

1. Disconnect the 7P connector from the recirculation control motor.

Incorrectly applying power and ground to the


Incorrectly applying power and ground to the recirculation control motor will damage it. Follow the instructions carefully.

2. Connect battery power to terminal No. 1 of the recirculation control motor, and ground terminal No.

2; the recirculation control motor should run, and stop at Fresh. If it doesn't, reverse the connections; the recirculation control motor should run, and stop at Recirculate. When the recirculation control motor stops running, disconnect battery power immediately.

RECIRCULATION CONTROL MOTOR

3. If the recirculation control motor did not run in step 2,


3. If the recirculation control motor did not run in step 2, remove it, then check the recirculation control linkage and door for smooth movement.

• If the linkage and door move smoothly, replace the recirculation control motor (see page 21-64).

• If the linkage or door sticks or binds, repair them as needed.

• If the recirculation control motor runs smoothly, go to step 4.

4. Measure the resistance between terminals No. 5 and No. 7 of the recirculation control motor. It should be between 4.2 and 7.8 kO.

5. Reconnect the recirculation control motor 7P connector, then turn the ignition switch to ON (II).

6. Using the backprobe set, measure the voltage between terminals No. 3 and No. 7 of the 7P connector.

Fresh: About 1.0 V

Recirculate: About 4.0 V

7. If either the resistance or the voltage readings are not as specified, replace the recirculation control motor (see page 21-64).

    Mode Control Motor Test
    NOTE: Before testing the motor, check for HVAC DTCs (see page 21-101). 1. Disconnect the 7P connector from the mode control motor. Incorrectly applying power and ground to the mode control mo ...

    Climate Control Unit Removal / Installation
    With Navigation 1. Remove the passenger's dashboard undercover (see page 20-170). 2. Disconnect the connectors (A). Loosen the bolt (B) and remove the bolts (C) from the climate control unit (D) ...

    See also:

    Front Door Outer Handle Replacement
    NOTE: - Put on gloves t o protect your hands. - Take care not to scratch the door. 1 . Remove the door panel: - 2-door (see page 20-12) - 4-door (see page 20-17) 2. Disconnect the power door ...

    Playing Discs (Models with navigation system)
    Playing Discs (Models with navigation system) Your vehicle’s audio system has an in-dash disc changer with the same controls used for the radio. To operate the disc changer, the ignition ...

    Symptom Troubleshooting
    VSA activation indicator does not go off, and no DTCs are stored NOTE: If the VSA modulator was replaced prior to the activation indicator turning on, do the VSA sensor neutral position memorizati ...