Honda Accord: Rearview Mirror Replacement - Mirrors - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Rearview Mirror Replacement

Without Automatic Dimming Mirror

1. Turn the rearview mirror base (A) 90 В°.

2. Slide the rearview mirror base (A) down toward the


2. Slide the rearview mirror base (A) down toward the bottom of the windshield to detach it from the spring (B) in the mount (C).

3. If necessary, remove the spring from the mount.


3. If necessary, remove the spring from the mount.

4. Install the rearview mirror in the reverse order of removal.

With Automatic Dimming Mirror

1. Pry out the rearview mirror harness cover (A) to release the hooks (B), then slide the cover rearward, and remove the cover by releasing the hooks (C) of the rearview mirror harness cover base (D).

2. Disconnect the rearview mirror connector (A).


2. Disconnect the rearview mirror connector (A).

3. Loosen the TORX screw with a TORX T20 bit, then


3. Loosen the TORX screw with a TORX T20 bit, then slide the rearview mirror (A) rearward and off the mount (B).

4. Install the mirror in the reverse order of removal, and


4. Install the mirror in the reverse order of removal, and note these items: - Before installing the mirror, remove the TORX screw, and apply medium strength liquid thread lock to it.

- Make sure the connector is plugged in properly.

- Push the hooks into place securely

    Mirror Housing Cover Replacement
    1. Remove the mirror holder (see page 20-63). 2. From the mirror holder opening, release the hooks (A) of the mirror housing cover (B). 3. Release the hooks (A), then remove the mirror housing ...

    Glass
    ...

    See also:

    DTC Troubleshooting
    DTC B1280: Turn Signal Switch Circuit Malfunction NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see page 22-134). 1. ...

    Circuit Diagram
    ...

    B-CAN System Diagnosis Test Mode C
    Do this diagnosis if a component that is controlled by the B-CAN system does not stop or turn off. NOTE: • If the component does not turn on, go to B-CAN System Diagnosis Test Mode D {see p ...