Honda Accord: Rear License Plate Light Bulbs - Replacing Light Bulbs - Maintenance - Honda Accord 2013-2026 Owner's ManualHonda Accord: Rear License Plate Light Bulbs

When replacing, use the following bulbs.

1. Remove the license plate light assembly by

1. Remove the license plate light assembly by pushing the left edge of the lens toward the right and pulling the assembly out.

2. Remove the lens by pushing the tabs.

2. Remove the lens by pushing the tabs.
3. Remove the old bulb and insert a new bulb.

    Taillight and Back-Up Light Bulbs
    When replacing, use the following bulbs. 1. Remove the holding clips using a flat-tip screwdriver, then pull the lining back. 2. Turn the socket to the left and remove it. 3. Remove the ol ...

    High-Mount Brake Light Bulbs
    High-mount brake light bulbs are the LED type. Have an authorized Honda dealer inspect and replace the light bulbs. ...

    See also:

    Circuit Diagram
    ...

    Outside Air Temperature Sensor Replacement
    1 Disconnect the 2P connector (A) from the outside air temperature sensor (B). 2. Lift the tab (C) to release the lock, then remove the outside air temperature sensor from the front bumper. 3 ...

    Symptom Troubleshooting Index
    Power Door Locks/Kef less 1. Check for B-CAN DTCs. If any B-CAN DTCs are Indicated, refer to the B-CAN System Diagnosis Test Mode A (see page 22-134) and resolve them first. 2. If the door lock ...