Honda Accord: Rear Inner Fender Replacement
NOTE: Take care not to scratch the rear bumper or the body.
1. Remove the screws, then remove the rear inner fender (A) from the rear bumper (B) and the body.
2. Install the inner fender in the reverse order of removal.
Fuel Pipe Protector Replacement
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the body.
- When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
1. Remove the le ...
Rear Air Outlet Replacement
NOTE: Take care not to scratch the body.
1_ Remove the rear bumper (see page 20-260).
2. Release the hooks (A), then remove the rear air outlet
(B).
3. Install the air outlet by pushing on t ...
See also:
Piston Ring Replacement
1. Remove the piston from the engine block (see page
7-14).
2. Using a ring expander (A), remove the old piston
rings (B).
3. Clean all ring grooves thoroughly with a squared-off
broken ring ...
Washer Fluid Level Switch Test
Canada models
1. Remove the right inner fender (see page 20-290).
2. Disconnect the 2P connector (A) from the washer fluid
level switch (B).
3. Remove the washer fluid level switch from the
w ...
Dashboard Center Vent
Removal / Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and Equipment
Program; call 888-424-6857
With Navigation Sf stem
NOTE:
- Take care not to scratch the dashb ...