Honda Accord: Rear Door Sash Outer Trim
Replacement
4-door
NOTE: Take care not to scratch the door.
1. Remove the door outer molding (see page 20-54).
2. Pull up the door sash outer trim (A) to release the trim from the clips, and release the trim from between the door glass outer weatherstrip (B) and the door, then remove the trim. Take care not to damage the door glass outer weatherstrip.
3. If the old door sash outer trim will be reinstalled, and the clips are damaged or stress-whitened, replace them with new ones.
4. If the door sash outer trim (A) will be replaced, or the clips (B) are removed from the door, insert the trim between the door glass outer weatherstrip (C) and the door, and install the trim by pushing on the clip areas until the clips snap into place.
5. If the clips (A) are not removed from the door, install the door sash outer trim (B) by inserting it to the clips and between the door glass weatherstrip (C) and the door.
6. Reinstall the door outer molding (see page 20-54).
Rear Door Sash Inner Trim
Replacement
4-door
NOTE: Take care not to scratch the door.
1. Remove the door panel (see page 20-38).
2. Lower the glass fully.
3. Remove the door sash inner trim (A).
-1. Pull back the outside edge ...
Rear Door Glass Outer Weatherstrip
Replacement
4-door
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the door.
1. Remove these items:
- Door panel {see page 20-38)
- Plastic cover, as needed (see step 3 on page 2 ...
See also:
Replacing a Front Side Marker Light Bulb
1. To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, tu ...
Recommended Engine Oil
Oil is a major contributor to your engine's
performance and longevity. If you drive the
vehicle with insufficient or deteriorated oil,
the engine may fail or be damaged.
This seal indicates ...
Cylinder Head Installation
1. Install a new coolant separator (A) In the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and the engine block surface.
3. Install the new cylinder head gaske ...