Honda Accord: Rear Door Glass Outer Weatherstrip
Replacement - Doors - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Rear Door Glass Outer Weatherstrip Replacement

Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body / Doors / Rear Door Glass Outer Weatherstrip Replacement

4-door

NOTE: - Put on gloves to protect your hands.

- Take care not to scratch the door.

1. Remove these items: - Door panel {see page 20-38) - Plastic cover, as needed (see step 3 on page 20-42) 2. Remove the screws from the front and rear edges of the door.

3. From the Inside of the door, slide the clips (A) of the


3. From the Inside of the door, slide the clips (A) of the door glass outer weatherstrip (B) to release the hooks (C) from the flanges (D) of the door.

4. Pull u p the door glass outer weatherstrip (A) while


4. Pull u p the door glass outer weatherstrip (A) while passing the front and rear edges of the weatherstrip over the door sash outer trim (B) and the door outer molding (C), then remove the weatherstrip.

5. Before installing the door glass outer weatherstrip,


5. Before installing the door glass outer weatherstrip, slide the clips to the released position as in step 3.

6. Install the door glass outer weatherstrip, and slide the clips securely on to the flanges.

7. Reinstall all remaining removed parts and note these items: - Make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal out water.

- Check for water leaks (see step 9 on page 20-57).

    Rear Door Sash Outer Trim Replacement
    4-door NOTE: Take care not to scratch the door. 1. Remove the door outer molding (see page 20-54). 2. Pull up the door sash outer trim (A) to release the trim from the clips, and release the t ...

    Rear Door Outer Molding Replacement
    Special Tools Required KTC Trim Tool Set SOJATP2014* - Available through the Honda Tool and Equipment Program; call 888-424-6857 4-door N O T E : - If you remove the door outer molding, replace ...

    See also:

    Front Door Latch Replacement
    NOTE: Put on gloves to protect your hands. 1. Remove the door panel and the inner handle: - 2-door ( s e e p a g e 20-12) - 4-door (see page 20-17) 2. Remove the plastic cover, as needed (see st ...

    Disc Changer Error Messages (Models with navigation system)
    The chart on the right explains the error messages you may see in the center display while playing a disc. If you see an error message in the center display while playing a disc, press the ej ...

    Immobilizer-Keyless Control Unit Input Test
    NOTE: Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). 1. Remove the driver's dashboard lower cover (see page ...