Honda Accord: Rear Bumper Finisher Cover Replacement - Bumpers - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Rear Bumper Finisher Cover Replacement

2-door

NOTE: - Put on gloves to prevent damage.

- Take care not to scratch the rear bumper or the body.

- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Remove the screw and detach the clips. Pull the rear bumper finisher cover (A) forward to release the hooks (B), then remove the cover from the rear bumper (C).

NOTE: To release the clips, pry up on the center pin at the notch <D).

2. Install the cover in the reverse order of removal, and


2. Install the cover in the reverse order of removal, and note these items: - If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.

    Rear Bumper Removal/Installation
    NOTE: - Have an assistant help you when removing and installing the rear bumper. - Take care not to scratch the rear bumper or the body. - Put on gloves to protect your hands. - When prying ...

    Hood
    ...

    See also:

    Trunk Lid Torsion Bar Replacement
    Special Tools Required Torsion Bar Assembly Tool 07AAF-SNAA100 1. Remove the trunk lid torsion bars (A) from the torsion bar center clip (B). 3. Remove the torsion bar center clip (A) from the ...

    Installing a Child Seat with LATCH
    Your vehicle is equipped with LATCH (Lower Anchors and Tethers for CHildren) at the outer rear seats. The lower anchors are located between the seat-back and seat bottom, and are to be used ...

    Circuit Diagram
    ...