Honda Accord: Pump Pressure Test w i th T/N 07406-001000A or T/N
07406-001A101
Special Tools Required
-Pump Joint Adapter 07RAK-S040111 o r P/S Joint Adapter (pump) 07RAK-S040110
•Hose Joint Adapter 07RAK-S040122
•P/S Pressure Gauge 07408-001000A or 07406-001A101
Check the fluid pressure as follows to determine whether the trouble is in the pump or steering gearbox.
1. Check the power steering fluid level (see page 17-28).
2. Disconnect the pump outlet hose (A) from the pump outlet with care so as not t o spill the power steering fluid on the frame and other parts, then install the pump joint adapter o r P/S joint adapter (pump) o n the pump outlet (B).
3. Connect the hose joint adapter to the P/S pressure gauge, then connect the pump outlet hose to the hose joint adapter.
4. Install the P/S pressure gauge to the pump joint adapter or P/S joint adapter (pump).
5. Fully open the shut-off valve (A).
6. Start the engine, and let it idle.
7. Turn the steering wheel from lock to lock several times to warm the fluid to operating temperature at 158 В°F (70 В°C).
8. Measure steady-state fluid pressure while the engine is idling. If the pump is in good condition, the gauge .
should read no more than 1,470 kPa (15 kgf/cm2, 213 psi).
If the reading is high, check for: -Clogged or deformed iniet or return line between the pump and the steering gearbox.
-Clogged valve body unit.
9. Let the engine idle, and gradually close the shut-off valve and immediately read the pressure.
Do not keep the shut-off valve closed more than 5 seconds or the pump could be damaged by over-heating.
10. Immediately open the shut-off valve fully.
If the pump is in good condition, the gauge should read at least 8,140-8,830 kPa (83-90 kgf/cm2, 1,180 — 1,280 psi). A low reading means the pump output is too low for full assist. Repair or replace the pump.
Pump Pressure Test w i th T/N 07406-0010001
Special Tools Required
-Pump Joint Adapter 07RAK-S040111 or P/S Joint
Adapter (pump) 07RAK-S040110
-Hose Joint Adapter 07RAK-S040122
-P/S Pressure Gauge 07406-0010001
Check the fluid pressure as ...
See also:
ODS Unit Initialization
NOTE:
• After SRS unit or ODS unit is replaced, do this
procedure to initialize the ODS unit.
• ODS unit initialization will initialize both OPDS sensor
and front passenger's weight se ...
Stall Speed Test
1. Wake sure the transmission fluid is filled to the proper
level (see page 14-191).
2. Apply the parking brake, and block all four wheels.
3. Connect the HDS to the DLC (A) located under the
...
Power Seat Adjustment Switch
Test/Replacement
1. Remove the driver's seat (see page 20-194).
2. Remove the power seat adjustment switch knobs (A) and the recline cover from
the driver's seat.
• 4-door (see page 20-234)
• 2-door ...