Honda Accord: Power Window Master Switch Replacement
4-door
1. Carefully remove the power window master switch (A).
2. Disconnect the 37P connector (B) from the power window master switch, and the 13P connector (C) from the power mirror switch (D).
3. Remove the four screws and the power window master switch (A).
4. Install the switch in the reverse order of removal.
5. Reset the power window control unit (see page 22-280).
2-door
1. Remove the driver's door panel (see page 20-12).
2. Disconnect the 37P connector (A) from the power window master switch (B) and the 13P connector from the power mirror switch.
3. Remove the switch panel and armrest from the door panel (see page 20-12).
4. Remove the four screws and the power window master switch (A).
5. Install the switch in the reverse order of removal.
6. Reset the power window control unit (see page 22-280).
Rear Power Window Motor Test
1. Remove the rear power window switch (see page 22-307). 2. Test the motor in each direction by connecting battery power and ground to the rear power window switch 14P connector (A) according t ...Front Passenger's Power Window Switch Replacement
4-door 1. Carefully remove the front passenger's power window switch (A). 2. Disconnect the 37P connector (B) from the front passenger's power window switch. 3. Remove the four screws and th ...See also:
Forced Starting of Display
Special Tools Required
SCS Service Connector 07PAZ-0010100
1. Turn the ignition switch to LOCK (0).
2. Connect the SCS service connector (A) to the
navigation service connector (B) located behin ...
Fuel Filter Replacement
The fuel filter should be replaced whenever the fuel
pressure drops below the specified value (see page
11-308), after making sure that the fuel pump and the
fuel pressure regulator are OK.
1. R ...
General Troubleshooting Information
DTC (Diagnostic Trouble Codes)
The self-diagnostic function of the SRS unit allows it to
locate the causes of system problems and store this
information in memory. For easier troubleshooting, this
...