Honda Accord: Power Window Master Switch Input
Test
NOTE: Before testing, troubleshoot the multiplex Integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134).
1. Turn the ignition switch to LOCK (0), open and close the driver's door, then remove the power window master switch.
• 4-door (see page 22-305) • 2-door (see page 22-306) 2. Disconnect the 37P connector (A) from the power window master switch (B).
NOTE: The illustration shows 4-door.
*: With mirror defogger
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, go to step 4.
4. Reconnect the connector to the power window master switch, turn the ignition switch to ON (II), and do these input tests at the following connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, go to step 5.
5. T u r n t h e i g n i t i o n s w i t c h t o LOCK (0), o p e n a n d c l o s e t h e d r i v e r ' s d o o r , t h e n d i s c o n n e c t t h e 37P c o n n e c t o r f r o m t he power window master switch again.
6. With the connector still disconnected, do these input tests at the following connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, the power window master switch must be faulty, replace it.
NOTE: After replacing the power window master switch, reset the power window control unit (see page 22-280).
*: With mirror defogger
Function Test
NOTE: The right power mirror is controlled by the front
passenger's power w i n d o w s w i t c h . W h e n t h e power
mirror s w i t c h is o p e r a t e d , t h e d o o r m u l t i p l e x c o n ...
Front Passenger's Power Window
Switch input Test
1. Turn the ignition switch to LOCK (0), open and close the driver's door,
then remove the front passenger's
(passenger's) power window switch.
- • 4-door (see page 22-306)
• 2-door ( ...
See also:
Glove Box
Open the glove box by pulling the
handle to the left. Close it with a firm
push. Lock or unlock the glove box
with the master key.
An open glove box can cause
serious injury to your passe ...
Driver's Inner Middle Pad
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
* Available through the Honda Tool and Equipment
Program; call 888-424-6857
NOTE:
-Take care not to scratch the dashboard or
the related
pa ...
Engine Speed Limiter
If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused ...