Honda Accord: Power Window Master Switch Input Test
NOTE: Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134).
1. Turn the ignition switch to LOCK (0), open and close the driver's door, then remove the power window master switch.
• 4-door (see page 22-305)
• 2-door (see page 22-306)
2. Disconnect the 37P connector (A) from the door power window master switch (B).
The illustration shows 4-door.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
• If the terminals look OK, go to step 4.
4. Reconnect the connector to the power window master switch, turn the ignition switch to ON (II), and do these input tests at the following connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, go to step 5.
5. Turn the ignition switch to LOCK (0), open and close the driver's door, then disconnect the 37P connector from the power window master switch again.
6. With the connector stiii disconnected, do these input tests at the following connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, the door multiplex control unit must be faulty, replace the power window master switch.
- 4-door (see page 22-305)
- 2-door (see page 22-306)
NOTE: After replacing the power window master switch, reset the power window control unit (see page 22-280).
DTC Troubleshooting
DTC B112S; Driver's Power Window Motor A Pulse Malfunction DTC B1126: Driver's Power Window Motor B Pulse Malfunction NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instruc ...Front Passenger's Power Window Switch Input Test
1. Turn the ignition switch to LOCK (0), open and close the driver's door, then remove the front passenger's power window switch. • 4-door (see page 22-306) • 2-door (see page 22-307) ...See also:
APP Sensor Signal I n s p e c t i o n
NOTE:
- This procedure checks the APP sensor in its fully
closed position. In any other position, the APP sensor
stores DTCs which are covered in other
troubleshooting procedures.
- Check for P ...
Emissions Controls
The burning of gasoline in your
vehicle’s engine produces several byproducts.
Some of these are carbon
monoxide (CO), oxides of nitrogen
(NOx), and hydrocarbons (HC).
Gasoline evaporating fr ...
Shifting
To shift from Park to any position,
press firmly on the brake pedal, and
press the release button on the front
of the shift lever, then move the
lever. You cannot shift out of Park
when th ...