Honda Accord: Power Steering Hose, Line, and Pressure Switch
Replacement
Note these items during installation: -Connect each hose to the corresponding line securely until it contacts the stop on the line. Install the clamp or adjustable clamp at the specified distance from the hose end as shown.
-Check all clamps for deterioration or deformation; replace the clamps with new ones if necessary.
-Add the recommended power steering fluid to the specified level on the reservoir, and check for leaks.

Fluid Replacement
Check the reservoir (A) at regular intervals, and add the
recommended fluid as necessary. Always use Honda
Power Steering Fluid. Using any other type of power
steering fluid or automatic transmissi ...
Pump Replacement
1. Place a suitable container under the vehicle to catch
any spilled fluid.
2. Drain the power steering fluid from the reservoir (see
page 17-28).
3. Remove the drive belt (A) from the pump pu ...
See also:
Rewriting the ODO Data and
Transferring the Maintenance
Minder Data to a New Gauge Control
Module
NOTE:
• Obtain a new gauge control module before starting
the rewriting process. Only new gauges can be
rewritten.
• Rewriting is not possible on a gauge control module
that will not ...
Column Cover Removal/Installation
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch or damage the column covers.
- Do not pry the cover surface with any tools.
1. Adjust the steering column to the full ...
Switch Test/Replacement
1. Separate the lumbar support switch cover (A) from
the switch (B).
2. Disconnect the 5P connector (C) from the switch.
3. Check for continuity between the terminals in each
switch position a ...