Test/Replacement

EX-L, EX-L PZEV models 1. Remove the cover (A), then disconnect BP connector (B). 2. Turn the ignition switch to ON (II). 3. Measure the voltage between terminal No. 2 and body ground. вР...

Component Location Index

...

See also:

MICU Input Test
NOTE: # Before t e s t i n g , t r o u b l e s h o o t the m u l t i p l e x i n t e g r a t e d control unit first, using B-CAN System D i a g n o s i s Test Mode A (see page 22-134). • B ...

Rocker Arm Assemblf Installation
1. Reassemble the rocker arm assembly (see page 6-82). 2. Clean and dry the No. 5 rocker shaft holder mating surface. 3. Apply liquid gasket P/N 08717-0004, 08718-0003, or 08718-0009 to the cy ...

Headlight Adjustment
Headlights become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off. Before adjusting the headlights: • Park the vehicle on a level ...