Honda Accord: Power Mirror Switch
Test/Replacement
1. Remove the power window master switch.
• 4-door (see page 22-305) • 2-door (see page 22-306) 2. Disconnect the 13P connector from the power mirror switch (A).
3. Check for continuity between the terminals in each switch position according to the table.
4. If the continuity is not as specified, remove the screws and replace the power mirror switch.
Front Passenger's Power Window
Switch input Test
1. Turn the ignition switch to LOCK (0), open and close the driver's door,
then remove the front passenger's
(passenger's) power window switch.
- • 4-door (see page 22-306)
• 2-door ( ...
Power Mirror Actuator Test
1. Remove the mirror mount cover (see page 20-62).
2. Disconnect the 8P connector (A) from the power
mirror actuator (B).
3. Check the actuator operation by connecting battery
power and ground ...
See also:
DTC Troubleshooting
DTC P0101: MAF Sensor Circuit
Range/Performance Problem
NOTE:
- Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information (see ...
Audio System Theft Protection*
The audio system is disabled when it is disconnected from the power source,
such as
when the battery is disconnected or goes dead.
• Reactivating the audio system
1. Set the power mode to ON, ...
Brake Assist System
• Brake Assist System
Designed to assist the driver by generating greater braking force when you
depress
the brake pedal hard during emergency braking.
• Brake assist system operation
Press ...