Honda Accord: Power Mirror Actuator Test
1. Remove the mirror mount cover (see page 20-62).
2. Disconnect the 8P connector (A) from the power mirror actuator (B).
3. Check the actuator operation by connecting battery power and ground according to the table.
4. If the mirror fails to work properly, check for an open or high resistance in the wire between the connector and the mirror holder. If the wire is OK, replace the mirror actuator.
Defogger Test
5. Measure the resistance between terminals No. 1 and No. 3 of the 8P connector. There should be about 7 0 .
6. If the resistance is not as specified, check for an open or high resistance in the wire between the connector and the mirror holder. If the wire is OK, replace the mirror holder.
Power Mirror Switch
Test/Replacement
1. Remove the power window master switch.
• 4-door (see page 22-305)
• 2-door (see page 22-306)
2. Disconnect the 13P connector from the power mirror
switch (A).
3. Check for contin ...
Power Mirror Actuator Replacement
Removal
1. Remove the mirror holder (see page 20-63).
2. Remove the power mirror (see page 20-62), and
disconnect the power mirror 8P connector from the
door wire harness.
3. Remove the gaske ...
See also:
Inspection and Maintenance
For your safety, perform all listed inspections and maintenance to keep your
vehicle
in good condition. If you become aware of any abnormality (noise, smell,
insufficient
brake fluid, oil resi ...
Low Smart Entry Remote SignalStrength*
The vehicle transmits radio waves to locate the smart entry remote when
locking/
unlocking the doors, opening the trunk, or to start the engine.
In the following cases, locking/unlocking the door ...
Armrest
To use the console lid as an armrest,
slide it to one of its three positions. ...