Honda Accord: Piston Installation - Engine Block - Engine Mechanical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Piston Installation

If the Crankshaft is Already Installed

1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed.

2. Remove the connecting rod caps, then install the ring compressor, and check that the bearing is securely in place.

3. Apply new engine oil to the piston, the inside of the ring compressor, and the cylinder bore, then attach the ring compressor to the piston/connecting rod assembly.

4. Position the mark (A) to face the cam chain side of the engine block.

5. Position the piston in the cylinder, and tap it in using


5. Position the piston in the cylinder, and tap it in using the wooden handle of a hammer (A).

Push down on the ring compressor (B) to prevent the rings from expanding before entering the cylinder bore.

8. Stop after the ring compressor pops free, and check


8. Stop after the ring compressor pops free, and check the connecting rod-to-rod journal alignment before pushing the piston into place.

7. Check the connecting rod bearing clearance with plastigage (see page 7-9).

8. Inspect the connecting rod bolts (see page 7-28).

9. Apply new engine oil to the bolt threads, then install the connecting rod caps with bearings. Torque the bolts to 41 N-m (4.2 kgfm, 30 Ibf-ft).

10. Tighten the connecting rod bolts an additional 120 Р’В°.

NOTE: Remove the connecting rod bolt if you tightened it beyond the specified angle, and go back to step 8 of the procedure. Do not loosen it back to the specified angle.

If the Crankshaft is Not Installed


If the Crankshaft is Not Installed

1. Remove the connecting rod caps, then install the ring compressor, and check that the bearing is securely in place.

2. Apply new engine oil to the piston, the inside of the ring compressor, and the cylinder bore, then attach the ring compressor to the piston/connecting rod assembly.

3. Position the mark (A) to face the cam chain side of the engine block.

4. Position the piston in the cylinder, and tap it in using


4. Position the piston in the cylinder, and tap it in using the wooden handle of a hammer (A).

Push down on the ring compressor (B) to prevent the rings from expanding before entering the cylinder bore.

5. Position all pistons at top dead center (TDC).


5. Position all pistons at top dead center (TDC).

    Piston Ring Replacement
    1. Remove the piston from the engine block (see page 7-14). 2. Using a ring expander (A), remove the old piston rings (B). 3. Clean all ring grooves thoroughly with a squared-off broken ring ...

    Connecting Rod Bolt Inspection
    1. Measure the diameter of each connecting rod bolt at point A and point B. 2. Calculate the difference in diameter between point A and point B. Point A-”Point B = Difference in Diameter D ...

    See also:

    Component Replacement/Inspection After Deployment
    NOTE: • Before doing any SRS repairs, check the DTCs (see page 24-36) for the less o b v i o u s deployed components (seat belt t e n s i o n e r s , front impact sensors, side airbag sensors ...

    Charging System Indicator Circuit Troubleshooting
    troubleshooting the charging system indicator. 1. Turn the ignition switch to ON (II). Does the charging system indicator come on? YES-Go to step 2. NO-Go to step 14. 2. Start the engine. ...

    Tire Service Life
    The life of your tires is dependent on many factors, including driving habits, road conditions, vehicle loading, inflation pressure, maintenance history, speed, and environmental conditions (eve ...