Honda Accord: Passenger's Under-dash Fuse/Relay
Box (MICU) Removal and
Installation - Under-dash Fuse/Relay Box - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Passenger's Under-dash Fuse/Relay Box (MICU) Removal and Installation

Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Under-dash Fuse/Relay Box / Passenger's Under-dash Fuse/Relay Box (MICU) Removal and Installation

NOTE: SRS components are located in this area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions, and procedures (see page 24-25) before doing repairs or servicing.

Removal

1. Do the battery terminal disconnection procedure (see page 22-91).

2. Remove the passenger's kick panel: • 4-door (see page 20-107) • 2-door (see page 20-105) 3. Disconnect the connectors from the passenger's under-dash fuse/relay box (A).

4. Loose the mounting bolt from the lower side of


4. Loose the mounting bolt from the lower side of passenger's under-dash fuse/relay box.

5. Remove the mounting bolt from the upper side of passenger's under-dash fuse/relay box, and remove the passenger's under-dash fuse/relay box.

Installation

1. Install the relays and connect the connectors to the passenger's under-dash fuse/relay box, then install the passenger's under-dash fuse/relay box in the reverse order of removal.

2. Install the removed parts in the reverse order of removal.

3. Do the battery terminal reconnection procedure (see page 22-91).

4. Confirm that all systems work properly.

    Driver's Under-dash Fuse/Relay Box (MICU) Removal and Installation
    Special Tools Required Relay Puller 07AAC-000A1A0 USA models NOTE; SRS components are located in this area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), an ...

    Battery
    ...

    See also:

    Valve, Spring, and Valve Seal Removal
    Special Tools Required Valve Spring Compressor Attachment 07757-PJ1010A Identify the valves and the valve springs as they are removed so that each item can be reinstalled in its original position. ...

    Shift Lever Position Indicators
    These indicators on the instrument panel show which position the shift lever is in. Using a paddle shift mode, the gear position indicator shows you the selected gear number. The ‘‘D ...

    Bearing Removal
    Special Tools Required •Attachment, 78x80 mm 07NAD-PX40100 -Driver Handle, 15 x 135L 07749-0010000 -Bearing Driver Attachment, 42 x 47 07746-0010300 1. Remove the idler gear shaft (see page 1 ...