Honda Accord: Passenger's Middle Pad
Removal/Installation - Dashboard - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Passenger's Middle Pad Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Honda Tool and Equipment Program; call 888-424-6857

SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repairs or service.

NOTE: - Take care not to scratch the dashboard or the related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Do the battery terminal disconnection procedure (see page 22-91), then wait at least 3 minutes before beginning work.

2. Remove these items: - Center pocket: - Without navigation system (see page 20-168) - With navigation system (see page 20-169) - Passenger's dashboard trim (see page 20-173) - Dashboard center vent (with navigation system) (see page 20-178) - Audio-HVAC module: - Without navigation system (see page 23-115) - With navigation system (see page 23-238) - Passenger's dashboard side vent (see page 20-177) - Passenger's airbag (see page 24-212)

3. Gently pull out along the edge of the passenger's middle pad (A) to release the hooks (B), then remove the pad.

4. Install the pad in the reverse order of removal, and


4. Install the pad in the reverse order of removal, and note these items: - Push the hooks into place securely.

- Do the battery terminal reconnection procedure (see page 22-91).

- Check for any DTCs that may have been set during repairs, and clear them.

    Driver's Inner Middle Pad Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* * Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: -Take care not to scratch the dashboard or the related pa ...

    Column Cover Removal/Installation
    NOTE: - Put on gloves to protect your hands. - Take care not to scratch or damage the column covers. - Do not pry the cover surface with any tools. 1. Adjust the steering column to the full ...

    See also:

    Cylinder Head Inspection for Warpage
    1. Remove the cylinder head (see page 6-76). 2. Inspect the camshaft (see page 6-84). 3. Check the cylinder head for warpage. Measure along the edges, and three ways across the center. - If ...

    Control Unit Input Test
    NOTE: Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). Driver's MICU 1. Turn the ignition switch to LOCK (0), ...

    Owner’s Maintenance Checks
    You should check the following items at the specified intervals. If you are unsure of how to perform any check, turn to the appropriate page listed. Engine oil level Check every time you fi ...