Honda Accord: Parking Brake Switch Test
NOTE: if both the ABS/VSA indicator and the brake system indicator come on at the same time, check the VSA system for DTCs first (see page 19-48).
1. Remove the center console (see page 20-158).
2. Disconnect the parking brake switch connector (A) from the parking brake switch (B).
3. Check for continuity between the switch terminal (C) and body ground.
В« With the parking brake lever pulled, there should be continuity.
- With the parking brake lever released, there should be no continuity.
NOTE: If the parking brake switch and the brake fluid level switch are OK, but the brake system indicator does not function, do the gauge control module self-diagnostic function (see page 22-332).
4. Reconnect the parking brake switch connector.
5. Install the center console (see page 20-158).
Brake Fluid Level Switch Test
NOTE: If both the ABSA/SA indicator and the brake system indicator come on at the same time, check the VSA system for DTCs first (see page 19-48). 1. Disconnect the brake fluid level switch conne ...See also:
Training HomeLink
Before you begin - If you just
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first butto ...
Trim Removal/Installation - Pillar
Areas
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
A-Pillar Trim
SRS components are located in this area. Review the ...
Replacing the High-mount Brake Light Bulb
1. Open the trunk, and remove the
socket from the light assembly by
turning it one-quarter turn counterclockwise.
2. Pull the bulb straight out of its
socket. Push the new bulb straight
int ...