Honda Accord: Parking Brake
To apply the parking brake, pull the lever up fully. To release it, pull up slightly, push the button, and lower the lever. The parking brake indicator on the instrument panel should go out when the parking brake is fully released.
Driving the vehicle with the parking brake applied can damage the rear brakes and hubs. A beeper will sound if the vehicle is driven with the parking brake on.
Moonroof
If equipped
The moonroof can be tilted up in the
back for ventilation, or it can be slid
back into the roof. Use the switch on
the front ceiling to operate the
moonroof. You must turn the
...
See also:
Fuel Fill Door Adjustment
1. Slightly loosen the hinge mounting bolts (A).
2 . Adjust the fuel fill door (B) in or out until it is flush with
the body, and up or down as necessary to equalize the
gaps.
3. Tighten the h ...
Mode Control Motor Test
NOTE: Before testing the motor, check for HVAC DTCs
(see page 21-101).
1. Disconnect the 7P connector from the mode control
motor.
Incorrectly applying power and ground to the mode
control mo ...
DTC Troubleshooting
DTC P0101: MAF Sensor Circuit
Range/Performance Problem
NOTE:
- Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information (see ...