Honda Accord: Park Lever Stop Inspection and Adjustment - Transmission End Cover - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Park Lever Stop Inspection and Adjustment

1. Set the park lever in the P position.

2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C).

Standard: 57.7-58.7 mm (2.27-2.31 in)

3. If the measurement is out of standard, select and


3. If the measurement is out of standard, select and install the appropriate park lever stop (A) from the table.

PARK LEVER STOP


PARK LEVER STOP

4. After replacing the park lever stop, make sure the


4. After replacing the park lever stop, make sure the distance is within tolerance.

    End Cover Removal
    Special Tools Required Mainshaft Holder 07GAB-PF50101 1. Remove the three bolts (D) securing the ATF cooler inlet line brackets, the ATF filter bracket bolts (E), the ATF cooler line banjo bolts ...

    Idler Gear Shaft Bearing Replacement
    Special Tools Required -Adjustable Bearing Puller, 25—40 mm 07736-A01000B •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 52 x 55 mm 07746-0010400 1. Remove the idler gear shaft be ...

    See also:

    Fuel Pressure Relieving
    Before disconnecting fuel lines or hoses, relieve pressure from the system by disabling the fuel pump, running the engine until it stalls, then and disconnecting the fuel line/quick connect fitting ...

    CKP Sensor Replacement
    1. Raise the vehicle on a lift. NOTE: Make sure the vehicle is level, because engine oil will drip out when you remove the sensor. 2. Remove the CKP sensor cover (A). 3. Disconnect the CKP s ...

    Beverage Holders
    Be careful when you are using the beverage holders. A spilled liquid that is very hot can scald you or your passengers. Spilled liquids can damage the upholstery, carpeting, and electrical c ...