Honda Accord: Outside Air Temperature Sensor Test - Gauges - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Outside Air Temperature Sensor Test

1 Remove the outside air temperature sensor (see page 22-353).

2. Dip the sensor in ice water, and measure the resistance. Then pour warm water on the sensor, and check for a change in resistance.

3. Compare the resistance reading between terminals No, 1 and No. 2 of the outside air temperature sensor with the specifications shown in the graph; the resistance should be within the specifications.

OUTSIDE AIR TEMPERATURE SENSOR

TEMPERATURE


TEMPERATURE

4. If the resistance is not as specified, replace the outside air temperature sensor (see page 22-353).

    Outside Air Temperature indicator Calibration
    NOTE: To test the outside air temperature sensor (see page 21-185). Description The outside air temperature sensor is located behind the center of the front bumper. The gauge control module uses ...

    Outside Air Temperature Sensor Replacement
    1 Disconnect the 2P connector (A) from the outside air temperature sensor (B). 2. Lift the tab (C) to release the lock, then remove the outside air temperature sensor from the front bumper. 3 ...

    See also:

    ATF Feed Pipe Replacement
    1. Remove the snap rings (A), the ATF feed pipes (B), and the feed pipe flanges (C) from the end cover (D). NOTE: Replace the end cover, if the 1st clutch ATF feed pipe (E) replacement is require ...

    Clutch Disassembly
    Special Tools Required Clutch Spring Compressor Set 07LAE-PX40000 1. Remove the snap ring using a screwdriver. 2. Remove the clutch end-plate (A), the clutch discs (B) (5), the clutch wave-plate ...

    Controls
    This chapter explains how to operate the various controls necessary for driving. ...