Honda Accord: Output Shaft (Countershaft) Speed Sensor Replacement - PGM-FI System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Output Shaft (Countershaft) Speed Sensor Replacement

NOTE: For A/T models (see page 14-188).

M/T

1. Disconnect the output shaft (countershaft) speed sensor 3P connector (A).

2. Remove the output shaft (countershaft) speed sensor


2. Remove the output shaft (countershaft) speed sensor (B).

3. Install the parts in the reverse order of removal with a new O-ring (C).

    ECT Sensor 2 Replacement
    1. Remove the front splash shield, (see page 20-291) 2. Drain the engine coolant (see page 10-6). 3. Disconnect the ECT sensor 2 connector (A), then remove ECT sensor 2 (B). 4. Install ECT sen ...

    Knock Sensor Replacement
    1. Remove the intake manifold (see page 9-4). 2. Disconnect the knock sensor connector (A). 3. Remove the knock sensor (B). 4. Install the parts in the reverse order of removal. ...

    See also:

    Rearview Mirror Replacement
    Without Automatic Dimming Mirror 1. Turn the rearview mirror base (A) 90 В°. 2. Slide the rearview mirror base (A) down toward the bottom of the windshield to detach it from the spring (B) in ...

    Blower Unit Removal/Installation
    1. Remove the glove box (see page 20-174). 2. Remove the passenger's undercover (see page 20-170). 3. Remove the right kick panel (see page 20-107). 4. Remove the dust and pollen filter asse ...

    Troubleshooting
    Special Tools Required Vacuum Pump/Gauge, 0-”30 inHg Snap-on YA4000A or equivalent commercially available NOTE: - Check the vacuum hoses and the lines for damage and proper connections befor ...