Honda Accord: Opening/Closing theWindows and Moonroof with the Key
You can open and close the windows and the moonroof (if equipped) with the key in the driver’s door lock.
To open:
1. Insert the key in the driver’s door lock.
2. Turn the key clockwise, then release it.
3. Turn the key clockwise again, and hold it. Both windows and the moonroof start to open. To stop the windows and the moonroof, release the key.
4. To open the windows and the moonroof further, turn and hold the key again (within 10 seconds of step 2).
To close:
1. Insert the key in the driver’s door lock.
2. Turn the key counterclockwise, then release it.
3. Turn the key counterclockwise again, and hold it. Both windows and the moonroof start to close.
To stop the windows and the moonroof, release the key.
4. To close the windows and the moonroof further, turn and hold the key again (within 10 seconds of step 2).
NOTE: If the windows and the moonroof stop before the desired position, repeat steps 2 and 3.
Opening theWindows and Moonroof with the Remote Transmitter
You can open both windows and the
moonroof (if equipped) from the
outside with the remote transmitter.
1. Press the UNLOCK button once
to unlock the driver’s door.
2. Press the UNLOCK butt ...
Moonroof
If equipped
The moonroof can be tilted up in the
back for ventilation, or it can be slid
back into the roof. Use the switch on
the front ceiling to operate the
moonroof. You must turn the
...
See also:
General Troubleshooting Information
Intermittent Failures
The term Intermittent failure means a system may have
had a failure, but it checks OK now. If the malfunction
indicator lamp (MIL) on the dash does not come on,
check for poo ...
Accessories
When installing accessories, check the following:
• Do not install accessories on the windshield. They can obstruct your view
and
delay your reaction to driving conditions.
• Do not install ...
DTC Troubleshooting
DTC indicator A: Climate Control Unit Internal
Error
NOTE: Check the battery condition (see page 22-90) and
the charging system (see page 4-25).
1. Turn the ignition switch to LOCK (0), and then ...