Honda Accord: Opening and Closing the Hood - Before Driving - Honda Accord 2008-2012 Owner's ManualHonda Accord: Opening and Closing the Hood

1. Park the vehicle, and set the

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard.

The hood will pop up slightly.

2. Reach in between the hood and

2. Reach in between the hood and the front grille with your fingers.

The hood latch handle is above the ‘‘H’’ logo. Push this handle up until it releases the hood. Lift the hood.

If the hood latch handle moves stiffly, or if you can open the hood without lifting the handle, the mechanism should be cleaned and lubricated.

3. 4-cylinder models

3. 4-cylinder models

Holding the grip, pull the support rod out of its clip. Insert the end into the hole in the hood designated by an arrow.

To close the hood, lift it up slightly to remove the support rod from the hole. Put the support rod back into its holding clip. Lower the hood to about a foot (30 cm) above the fender, then let it drop. Make sure it is securely latched.

V6 models

V6 models

Lift the hood up most of the way.

The hydraulic supports will lift it up the rest of the way and hold it up.

To close the hood, lower it to about a foot (30 cm) above the fender, then press down firmly with your hands. Make sure the hood is securely latched.

    Check Fuel Cap Message
    Your vehicle’s onboard diagnostic system will detect a loose or missing fuel fill cap as an evaporative system leak. The first time a leak is detected a ‘‘CHECK FUEL CAP’’ message ...

    Oil Check
    Wait a few minutes after turning the engine off before you check the oil. 1. Remove the dipstick (orange handle/loop). 2. Wipe off the dipstick with a clean cloth or paper towel. 3. Inser ...

    See also:

    Driver's Power Window Motor Test
    Motor Test 1. Remove the power window master switch. • 4-door (see page 22-305) • 2-door (see page 22-306) 2. Test the motor in each direction by connecting battery power and ground t ...

    Safety When Performing Maintenance
    Some of the most important safety precautions are given here. However, we cannot warn you of every conceivable hazard that can arise in performing maintenance. Only you can decide whether or not ...

    ATF Pump Inspection
    1. Install the ATF pump drive gear (A), the driven gear (B), and the ATF pump driven gear shaft (C) in the main valve body (D). Lubricate all parts with ATF, and install the ATF pump driven gear wi ...