Honda Accord: Openers
- Component Location Index
- Hood Opener Cable Replacement
- Trunk Lid Opener Cable/Fuel Fill Door Opener Cable Replacement
- Hood Latch Replacement
- Hood Release Handle Replacement
- Trunk Lid Opener/Fuel Fill Door Opener Replacement
- Trunk Lid Latch Replacement
Rear Air Outlet Replacement
NOTE: Take care not to scratch the body.
1_ Remove the rear bumper (see page 20-260).
2. Release the hooks (A), then remove the rear air outlet
(B).
3. Install the air outlet by pushing on t ...
See also:
DTC Troubleshooting
DTC 81152: Gauge Control Module (EEPROM)
Error
NOTE: If you are troubleshooting multiple DTCs, be sure
to follow the instructions in B-CAN System Diagnosis
Test Mode A (see page 22-134).
1. Cle ...
Reverse Idler Gear Removal and
Installation
Removal
1. Remove the bolt (A) securing the reverse idler gear
shaft holder (B).
2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear
shaft (D), and pull it to remove the reverse idler gea ...
Secondary Shaft Disassembly,
Inspection, and Reassembly
1. Inspect the thrust needle bearings a n d the needle bearings for g a l l i
n g and rough movement
2. Inspect the splines for excessive wear and damage.
3. Check the shaft bearing surface fo ...