Honda Accord: Oil Seal Replacement
Special Tools Required
•Driver Handle, 15 x 135L 07749-0010000
•Oil Seal Driver Attachment 07947-SD90101
-Oil Seal Driver Attachment 07JAD-PH80101
1. Remove the oil seal from the transmission housing.
2. Remove the oil seal from the torque converter housing.
3. Install a new oil seal (A) flush with the transmission housing using the driver handle and the oil seal driver attachment.
Differential Carrier and Final Driven Gear Replacement
1. Remove the final driven gear (A) from the differential carrier (B). NOTE: Differential carrier bolts have left-hand threads. 2. Install the final driven gear in the direction shown on the ...Carrier Bearing Outer Race Replacement
Special Tools Required -Driver Handle, 15 x 135L 07749-0010000 -Attachment, 78 x 80 mm 07NAD-PX40100 -Attachment, 72 x 75 mm 07746-0010600 NOTE: -The bearing and the bearing outer race should be ...See also:
Features
This chapter describes how to operate technology features. ...
Upper Arm Replacement
Special Tools Required
-Ball Joint Thread Protector, 10 mm
07AAF-SECA120
- Ball Joint Remover, 28 mm 07MAC-SL0A202
1. Raise and support the vehicle (see page 1-13).
2. Remove the front wheel.
...
Oil Pressure Switch Test
1 Disconnect the oil pressure switch connector (A) from
the oil pressure switch (B).
2. Check for continuity between the oil pressure switch
terminal and the engine (ground). There should be
con ...