Honda Accord: Oil Pump Chain inspection - Engine Lubrication - Engine Mechanical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Oil Pump Chain inspection

1. Remove the oil pan (see page 7-11).

2. Measure the oil pump chain auto-tensioner rod length. If the length is over the service limit, replace the oil pump chain (see page 8-25).

Oil Pump Chain Auto-Tensioner Rod Length

Service Limit: 13 mm (0.51 in)

3. Install the oil pan (see page 7-30).


3. Install the oil pan (see page 7-30).

    Balancer Shaft Inspection
    1. Seat the balancer shaft by pushing it away from the oil pump sprocket end of the oil pump. 2. Zero the dial indicator against the end of the balancer shaft, then push the balancer shaft back a ...

    Oil Pump Chain Replacement
    NOTE: Keep the oil pump chain away from magnetic fields. Removal 1. Remove the drive belt (see page 4-30). 2. Remove the oil pan (see page 7-11). 3. Support the engine with a jack and a wood ...

    See also:

    Emissions Testing
    Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘ ...

    System Check
    1. Connect the HDS to the data link connector. 2. Turn the ignition switch to ON (II). 3. Monitor the SYSTEM CHECK in the IMMOBILIZER INFO with the HDS. 4. If the HDS displays NORMAL N-1,the ...

    Recirculation Control Motor Test
    '08-09 models 4-door with A/T and "10 model with A/T NOTE: Before testing the motor, check for HVAC DTCs (see page 21-9). 1. Disconnect the 7P connector from the recirculation control moto ...